Votre panier

Votre panier est vide.

Votre panier est vide.

Continuer le magasinage

RECHERCHE RAPIDE DE VÉHICULE

RECHERCHE VÉHICULE

Utilisateur

Daniel Waslenko

À rejoins en date due:

Jan. 20, 2016

Points

2650

Commentaire(s)

20

Questions votée(s)

0

Réponses votée(s)

0

Votes positifs

0

Votes contre

0

Votes reçus

5

Votes négatifs reçus

0

picto contact

Vous cherchez nos meilleurs participants ?

Voir les utilisateurs
picto contact

Vous n'avez pas trouvé ce que vous cherchiez ?

Posez une question

0

Obd2 fuse for 2016 rogue turn key

So I'm working on a 2016 nissan rogue turn key. Somehow when moving the obd2 port out of the way the 12v wire just fell out the back of the obd2 port and hit ground and popped the fuse. Any idea what fuse it is? I heard a faint pop from the drivers fuse box. Customer was already rushing us as she didnt understand what "plan to be without your vehicle for the day" means. So I threw it back together, but need to figure out what fuse it is. Anyone know what one to look for? I didnt see anything labeled obd2. Using evo all not that it matters

0

Transmission doesnt shift properly and CEL when remote starting 2003 trailblazer

Did an install on a 2003 trailblazer. ONLY when using the remote start it throws 3 codes P0740, p0785, p1860 all pertaining to the transmission. If you clear the codes, and dont use remote start they do not come back. I made sure the 2nd accessory is an accessory and not an ignition. Any idea what I may be missing? Using D2D

0

Unit flashes 5 times with hood closed

2010 toyota prius. Did install and it worked fine. Next day came back because it wont start. Lights flash 5 times indicating hood open. I disconnected hood switch and issue persists. Reprogrammed unit to the vehicle and it works again. Possibly bad unit? Service number 001a07 016839

0

Evo-nist1 sometimes wont start and lights flash 3 times.

2010 nissan maxima. Sometimes it starts fine, sometimes it doesnt start and the lights flash 3 times. Evo-nist1

0

2005 durango alarm goes off on startup

I did install with evo one 3x lock and set D2 to unlock before lock after. Alarm still goes off

0

How to wire 2006 ram for stand alone

Ignition plug is 6 pin with 5 wires in it. There is a green with yellow stripe which is supposed to be ignition but there is an empty pin between that and the 12v battery.

0

Evo-All on 2014 Nissan rogue causing check engine and 4WD error lights

It is a 2014 Nissan Rogue with the flip key. Installed using guide 75221 back in March of this year. Install was done by soldering. There was no issues during install, and no issues programming the module. I remote started the vehicle for 5 cycles before customer picked it up. No error lights. Customer called last week (8 months later) and said the check engine light came on, and the 4WD error light came on. They took it to the Nissan Dealership and they said the remote start is causing the issue because it was installed incorrectly. #1 I have done this exact install over a dozen times this past year and no one else has has an issue. #2 why would all of a sudden after 8 months it suddenly cause an issue? #3 is it possible there is a lag in the CAN Bus that is causing the error similar to some of the Chryslers where I need to change the firmware? #4 Why would this install be done 13 times on 14-18 Rogues and only this one have an issue?

0

2007 fordf250 anyone know where the TX RX wires are located?

can not find the harness on 2007 ford f250 that hs the TX RX wires i found all others

0

2011 Nissan Rogue Parking lights don't turn on

I connected it to the red wire with silver dots on the harness going to the back of the vehicle as listed in wirecolor.. There were a number of red with silver dots, but only one that had 12v + when the parking lights were turned on. I even manually fed 12v+ to the wire and they would not turn on. Is there any other way to power up the parking lights? is there any possible connection at the parking light switch?

0

2017 outlander diagram points to the 2015

Working on a 2017 outlander with a key start. Not one wire location matches the guide. I noticed the guide itself says up to 2015. Where is the wiring diagram for a 2017?

0

Where is the door lock data wire on an 03 liberty?

The location of the door lock data wire is blank ijn the guide. Where is it?

0

Need remote start on my 2016 Mustang GT Manual

I have a 2016 supercharges Ford Mustang GT 5.0 with a manual transmission my business uses as a show car (Currently $100k+ into the vehicle). I need a remote start put on it for demonstration (It isn't as much as a cool factor showing off our van). What needs to be done to get a remote start put on it? I can bypass the clutch using a 2 way toggle switch with resistors and diodes if need be (Did that before on a 2012 Wrangler). I am trying to install a state of the art system to use as a display piece at car shows with all the sensors, bells and whistles........ I am the only one to EVER sit in the vehicle let alone drive it so liability is not an issue. What do you reccomend to get a remote start done on this as it is not listed on the guide? Is there any kind of software in testing I can use as I want to get at least one show this year with a remote start installed on it? Our vehicle last year sold over 100 installs during the summer by going to shows

0

2015 Tundra with Evo One SOMETIMES cranks without starting

I installed an EVO-ONE on a 2015 Toyota Tundra. 1 out of 5 times when he engages the remote start, the truck will crank for around 8 seconds without starting. The other times it starts perfect. Tach is set to data only, and is not set to crank for 8 seconds. He said also every once in a while the lights on the dash will shut off at night after a few minutes of driving. I used the t harness and as always, i soldered the rest of the connections.

0

2012 KIA Optima shuts down after 5 minutes then restarts.

I did an install on a 2012 Kia Optima (standard key) with a Avital and EVO-ALL. It starts fine, but then it runs for 5-6 minutes then shuts off and restarts again. It doesn't do it every time, but when it does, it will do it over and over unless you shut it off with either the remote or the brake. When it shuts down, there are no parking light flashes, it just shuts off and a second later starts up again. The customer did not even notice until he was outside one if the times it restarted. I made sure that avital was set to standard tach and not virtual tach. What could be causing this issue? Is it possible the tach signal is being interrupted? If it is most likely the tach, would switching to virtual tach fix the issue? Customer lives an hour away, so I dont't want to have him keep driving back and forth over and over again trying to diagnose the issue.

1

EVO-ALL loses key data info when power is disconnected

It is on a 2008 Ford Mustang. Manufacture date is 06/2007. Tried installing with 2008 diagram, but nothing works over CAN (even wire colors are different on OBD2 plug on pin 3 and 11), so I went with the 2007 diagram. I have tried programming with 1 key, and 2 keys. Either way if power is lost, the next time you engage the remote start, the immobilizer light flashes and vehicle doesn't start. If you reprogram it again it works until power is disconnected again. I have installed over 500 of these units the past 2 years and I have never ever seen anything like this. Is it actually losing the key data, or is something else going on?

0

Data coverage 2015 Toyota Tacoma

Why is there no data support on the 2015 Tacoma? I can not see a 2015 vehicle having everything analog. why can I not find any wiring diagrams for it either?

0

How to hook EVO-All to Crimestopper FS-42 with data

Installing EVO-ALL with THAR-NIS1 on a 2008 PTS Nissan Altima. I had a Crimestopper FS-42 sitting in the shop for a while so I figure I would use that as the remote start portion. The FS-42 has two data ports, one ADS, and one FORTIN. The data plugs on the harness only seem to have one Fortin connection. How do I hook that up, or do I need to change the plug?

0

Where is the TPMS wire in a 2016 Rav4

The guide says it is a 20 pin blue connector in the driver kick pannel. Wire color is light brown. There is no light brown wire. The vehicle remote starts but the locks do not operate once it is remote started and it also does not shut off with the fob. It uses a key ignition.

0

How do you hook up door locks in 2004 Toyota Highlander?

There is the Purple unlock wire, Gray lock wire, and the brown wire. In order to lock the vehicle it says you need to break the brown wire, and in order to unlock the vehicle, you need to send a pulse the brown in addition to the purple. I was looking around and wirecolor says to use a relay. I hooked the relay up to break the brown wire using the door lock to pulse the relay and isolated the brown wire with a 3 amp diode. The unlock works perfect, but in order to lock i need to press it 3 times in order for it to lock. does anyone know the proper way to set this up as I must have something wrong

No results

picto contact

Vous cherchez nos meilleurs participants ?

Voir les utilisateurs
picto contact

Vous n'avez pas trouvé ce que vous cherchiez ?

Posez une question

Support Technique

Recherchez parmi nos produits les plus populaires et les sujets d'installation disponibles dans notre section Questions et réponses.

En savoir plus
Téléchargez notre application de guides de dépannage étape par étape disponible pour iOS et Android ou parcourez notre version de bureau.

En savoir plus
Accédez à la plus grande base de données de schémas de câblage et de photos en ligne de l'industrie. Un jeton gratuit est fourni dans chaque boîte EVO-SERIES.

En savoir plus
Vous n'avez pas trouvé l'information que vous cherchiez ? Posez-nous une question en remplissant le formulaire de demande de support technique. Un spécialiste produit vous répondra sous peu.

En savoir plus
Des solutions de contrôle à distance et de connectivité à la fine pointe de la technologie au soutien technique haut de gamme, découvrez pourquoi vous devriez choisir les produits Fortin.

En savoir plus

Ce site Web utilise des cookies pour vous garantir la meilleure expérience utilisateur. En poursuivant votre navigation sur notre site, vous acceptez notre utilisation des cookies. En savoir plus Continuer